Floorstanding L Screen With Pedestal - Knoll Antenna Workspaces Installation Instructions Manual

Floorstanding L Screen With Pedestal

Pattern Numbers Represented:
L Screen, YSFS_____
L Screen Corner Bracket, YSFSB
Parts List:
Screen Mounting Bracket (A)
#12 X ¾" Black Wood Screw (B)
Corner Bracket (C)
#12 x / " SM TRP Black Screw (D)
5
8
L Screen
Tools Needed:
Drill
Phillips #2 and #3 bits
/ " Drill Bit
1
8
Drill Stop
Pencil
STEPS
1. Build desk assembly with pedestal
(See desk supported by 25"H
storage assembly instructions).
2. Position (1) screen mounting bracket (A)
under the desk top; on the back edge of
the top. The flat portion of the bracket
should face the underside of the top.
: The bracket should be positioned
Note
so that its outside edge will fall
approximately 2" within the L-screen.
3. Temporarily attach the bracket (A)
to the underside of the top using (2)
#12 X ¾" black wood screws (B).
4. Place the floorstanding L-screen into
position around the corner of the
desk and level the glides on the desk
and the screen, as necessary.
(A) 3AB4043*
5. Under the desk, mark the three visible screen
mounting bracket (A) hole positions on the
interior of the L-screen with a pencil.
6. Position the corner bracket (C) under the
corner of the worksurface, but above the
pedestal top, so it sits against both sides of
the L screen, and mark the four hole positions
on the interior of the screen with the pencil.
7. Remove the L-screen and corner bracket
(C), and unscrew the screen mounting
bracket (A) from under the desk top.
8. Position the screen mounting bracket
(A) on the L-screen so it aligns with its
three corresponding pencil marks, and
then mark the upper three holes with
a pencil. There should be (6) marks for
the screen mounting bracket (A).
(B) 7196440 (C) 6942395
9. Place the screen mounting bracket aside,
and drill pilot holes with a
L-screen at the marked locations for the screen
mounting bracket (A) and the corner bracket
(C), taking care to not damage the exterior face
of the L-screen. Use a drill stop, if necessary.
10. Attach the brackets (A & C) to the L-screen,
utilizing the pre drilled holes, with (6) #12
X ¾" black wood screws (B) per screen
mounting bracket, and (4) #12 x
black screws (D) for the corner bracket (C).
11. Replace the L-screen screen around the
desk and re-attach the screen mounting
bracket (A) to the underside of the top
with the same (2) #12 X ¾" black wood
screws (B) previously removed.
(D) 7128440
/ " drill bit into the
1
8
5 / " SM TRP
8