Hard Surface Intermediate Screens - Full Depth For Use With Tops Without Hinged Access - Knoll Antenna Workspaces Installation Instructions Manual

Hard Surface Intermediate Screens - Full Depth
for Use with Tops without Hinged Access
Pattern Numbers Represented:
Intermediate Screens, YPSI___
Parts List:
Non-Upholstered Intermediate Screen Rail Clamp (A)
¼ - 20 x / " Black Oxide Machine Screw (B)
3
8
Screen
Tools Needed:
Drill
Phillips #2 and #3 bits
(A) 3AB1210*
STEPS
1. Determine the desired screen position along
the width of the table, and position the
screen on the worksurface accordingly.
2. Hook (1) non-upholstered intermediate screen
rail clamp (A) behind the back edge of the
worksurface so that the clamp's two "fins"
are above the worksurface and the two screw
holes are below the worksurface. Slide one
end of the screen's bottom extrusion onto the
"fins" to temporarily support the bracket.
3. Hook the second non-upholstered
intermediate screen rail clamp (A) on to the
front edge of the worksurface in a similar
fashion, sliding the "fins" into the other
end of the screen's bottom extrusion.
(B) 7019440
4. Insert (2) ¼ - 20 x / " black oxide machine
3
8
screws (B) into the holes under the back
rail clamp (A). Hold the clamp's "fins"
firmly against the side of the screen's
bottom extrusion and tighten the screws
against the bottom of the worksurface.
The ¼ - 20 x / " black oxide machine
NOTE: 3
8
screws (B) are to be treated as set screws and
will create the tight connection between the
screen's bottom extrusion and the worksurface.
The rail clamp (A) must be seated firmly within
the side of the bottom extrusion, but should not
be pressed tight against the bottom of the
worksurface. A space will remain between the
rail clamp and the bottom of the worksurface.
5. Repeat Step 4 with the second
(front) rail clamp (A).