Knoll Antenna Workspaces Installation Instructions Manual page 12

Table Desk (Flush Legs)
Pattern Numbers Represented:
Legs for Table Desks (Desk Height),
Starter Rails without End Caps,
Part List:
Table Desk Cradle (A)
Cradle Clamp Bracket (B)
Spacer (C)
#12 X ¾" Black Wood Screw (D)
¼-20 x 1" Machine Screw (E)
¼-20 x / " Machine Screw (F)
5
8
#14 x 1" FH Wood Screw (G)
Rails
Table Desk End Legs
Top
Tools Needed:
Drill
Phillips #2 and #3 bits
STEPS:
1. Attach table desk cradles (A) to
legs, (2) per leg, using (2) ¼-20 x 1"
machine screws (E) per cradle (A).
2. Attach (1) pair of horizontal rails to cradles
(A) by first fastening (2) cradle clamp
brackets (B) loosely to each cradle (A)
using (4) ¼-20 x / " machine screws (F).
5
8
: Rails are 3" shorter than top width.
NOTE
ie: 72" wide tops use 69" wide rails.
Slide one end of each rail into a cradle/clamp
assembly, with rail paint holes facing up and
toward the center of the table desk assembly.
Table Desk Assembly Plan
ANTENNA 02 G
A.) 3AB4069*
YELS__
YBRT_
D.) 7196440
NOTE
holes are to face down and toward
center of the table desk assembly.
NOTE
against (not on top of) the "fins" at the
back of the cradle. No endcaps are required.
Tighten the screws (F) in the cradle clamp
brackets (B).
3. Attach other ends of the rails to the (2) cradles
(A) in the other leg assembly as noted in step 2.
4. If applicable, attach suspended storage,
returns and/or electrical components at this
time. (see suspended storage, table desk with
return and electrical installation instructions).
3AB4069
E.) 7194140
3AB4040
Screw, Mach, FLP 1/4-20 X 1
: If a glass top is being used,
: End of rail must be fully inserted
B.) 3AB4007*
F.) 7189140
Screw, SM, FLP 14 X 1 Type A CAD or Zinc
5. Surfaces 48" wide and greater require a spacer
(C) for additional support. When necessary,
a spacer (C) should be placed between the
top of each rail and the underside of the top,
centered on the width of the top. Spacers
(C) are attached to the top using (1) #12 X
¾" black wood screw (D) per spacer.
6. Lay top on base assembly. Attach top using (2)
#14 x 1" FH wood screws (G) per cradle (A) into
pre-drilled holes in the underside of the top.
7. Adjust glides as needed to level table desk.
ANTENNA 02 F
Table Desk Assembly
C.) 3AB401252
3AB4012
G.) 7434100
7434100