Knoll Antenna Workspaces Installation Instructions Manual page 38

Mid Span Support Leg for Center Beam for 36"D Big Table
Pattern Numbers Represented:
Mid Span Support Leg, YILDD1
Parts List:
Spring Nut (A)
M6 x 16mm Internal Hex Drive Machine Screw (B)
Mid Span Support Leg
36"D Big Table Assembly
Tools Needed:
/ " or 4mm Allen Wrench
5
32
STEPS
Note: A mid span support leg for center beam
is required for supplementary support of 36"D
dual and single sided big tables with unsupported
spans wider than 54". For additional assembly
steps see Big Table with Intermediate Leg
instructions or Single Sided Big Table instructions.
1. Determine the location for the mid span
support leg. Be sure that the leg is
approximately centered on the length of
the beam, but be sure to not interfere
with any electrical/data components,
connections or access points.
(A) 3AB402196
2. At determined location insert (2) spring
nuts (A) into the horizontal slot on
the bottom of the center beam.
3. Place the mid span support leg into
position under the center beam, and slide
the spring nuts (A) so they align with the
holes in the top plate of the support leg.
(B) 3AB424640
4. Using a 5/32" or 4mm Allen wrench, attach the
support leg to the spring nuts (A) with (2) M6
x 16mm internal hex drive machine screws.
5. Adjust the glide on the support leg as
necessary to ensure that it provides
support to the beam, and that the
table assembly remains level.