Knoll Antenna Workspaces Installation Instructions Manual page 55

Electrical Components
Electrical Components: Power for Desk Rail
Pattern Numbers Represented:
Power Harness, YRPHE_ , YR1PHT_
Power Harness Mounting Brackets
for Desks, YRPHA_
Duplex Receptacles, YR1D_
Outlet Fillers, YROF
Raceway Covers, YRC__
Raceway End Caps, YRCE
Jumper Cables, YR1EJ_ , YR1TJ_
Parts List:
Power Harness Mounting Extrusion (A)
Right Hand Harness Mounting End Cap (B)
Left Hand Harness Mounting End Cap (C)
Spring Nut (D)
M6 x 14mm Machine Screw (E)
Bottom Power Harness Mounting Bracket (F)
Top Power Harness Mounting Bracket (G)
M6 x 70mm Machine Screw & Washer (H&I)
Power Harness
Duplexes
Jumper Cables
Raceway Covers
Raceway End Caps
Outlet Fillers
Tools Needed:
Drill
Phillips #2 and #3 bits
STEPS:
1. Attach right and left hand harness mounting
endcaps (B/C) on top of the desk rail
underneath the worksurface. Note: The
screws attaching the top to the worksurface
may need to be temporarily loosened to allow
the placement of the mounting endcaps.
The endcaps will hang from the rail.
2. Attach the power harness mounting extrusion
(A) to the endcaps (B/C) by sliding and
pressure fitting the endcaps into the extrusion.
3. Connect the endcaps (B/C) securely to the
power harness mounting extrusion (A) by
screwing (2) M6 x 14mm machine screws (E)
through the pre-drilled holes in the endcaps
and into the spring nuts (D) and tightening.
(A) 3AB501003*
(E) 3AB405640 (F) 3AB500800
(H) 3AB403500
4. Insert (2) additional spring nuts (D) into
the power harness mounting extrusion.
5. Insert bottom power harness mounting bracket
(F) into the bottom of the power harness.
6. Insert the top power harness mounting bracket
(G) into the top of the power harness.
7. Attach the two bracket (F/G) pairs and the
power harness to the power harness mounting
extrusion (A) using (1) M6 x 70mm machine
screw & washer (H&I) per pair. Each screw
should be threaded through a bottom mounting
bracket (F), the power harness, a top mounting
bracket (G), a washer, and lastly, a spring nut
(D) in the power harness mounting extrusion.
8. Insert duplexes into the inner terminals
of the power harness as required.
(B) 3AB501101* (C) 3AB501102*
(G) 3AB500100
9. Install jumper cables into the outer terminals
of the power harness as required.
: Arrows stamped into the molded
NOTE
plugs should be pointed up, indicating
proper orientation of the jumper cable.
10. Install raceway covers on both sides of
power harnesses by first aligning slotted
holes on the top of the raceway cover with
the tabs on top of the top power harness
mounting brackets (G). Swivel the cover
downward to engage the groove at the
bottom of the raceway cover with the bottom
lip of the bottom power harness mounting
brackets (F). Install outlet fillers (YROF) in all
unoccupied raceway knockout covers.
11. Install raceway end caps on raceway
covers for all power harness ends
without a connected jumper.
(D) 3AB402196
(H) 3AB403496