Knoll Antenna Workspaces Installation Instructions Manual page 65

Electrical Components: Desktop Outlet Center Module
and Desk Mounted Shroud
Parts List:
Shroud Weldment, 7½" (A) (or)
Shroud Weldment, 8¾" (B) (or)|
Shroud Weldment, 10" (C)
Lower Bracket (D)
#6 Torx Screw (E)
Thumb Screw (F)
Desktop Outlet Center Module, 3, 4 or 5 position (G)
Tools Needed:
#2 Phillips Driver
T15 Torx Driver, or ³/ " Allen Wrench
32
STEPS:
1. If applicable, install communication faceplates
and data modules, provided with the Desktop
Outlet Center Module (G), using individual data
port installation instructions, as required.
2. Insert the cordset/conduit feed on the Desktop
Outlet Center Module (G) through the center
front opening of the Shroud Weldment (A/B/C)
and route it downward. The cordset/conduit
feed may need to be aligned with the cutout at
the center of the Shroud Weldment (A/B/C).
3. Align the mounting holes in the underside
of the Desktop Outlet Center Module (G)
with the mounting holes on the Shroud
Weldment (A/B/C), and fasten with (4) #6
Torx Screws (E). Do not over-tighten.
4. Position the Shroud Weldment (A/B/C)
in the desired location at the edge of
the desktop. The rubber pads should
rest on the desktop surface.
5. Insert (2) Thumb Screws (F) into the
threaded holes on the Lower Bracket (D).
6. Install the Lower Bracket (D) onto the Shroud
Weldment (A/B/C). The cordset/conduit feed
on the Desktop Outlet Center Module (G)
can be routed behind or above the Lower
Bracket (D) as the bracket is installed.
7. Hand-tighten the Thumb Screws (F) to secure
the Shroud Weldment (A/B/C) to the desktop.
(A) 3AB5446* (B) 3AB5442*
(E) 3AB5433 (F) 3AB5038
Desktop Outlet Center Module & Desk Mounted Shroud-
Installed, Axonometric View
Desk Mounted Shroud
(C) 3AB5450*
(G) 3AB5451*
Note: 5 position cordset shown
Desktop Outlet Center Module with
Desk Mounted Shroud, Assembled
(D) 3AB5449*
Desktop Outlet Center Module