Knoll Antenna Workspaces Installation Instructions Manual page 59

Electrical Components: Surface Mounted Plugmold Raceway
Pattern Numbers Represented:
Plugmold, YRPM__
Plugmold Mounting Kit, YRPMK
Parts List:
Plugmold Mounting Rail (A)
Spring Nut (B)
M6 x 10mm Machine Screw (C)
Plugmold Assembly (D)
Center Beam (or)
Power Harness Mounting Bracket for Desks
Tools Needed:
Drill|
Phillips #2 and #3 bits
STEPS
1. Install (3) spring nuts (B) into the bottom
slot in the center beam of the Big Table
or in the Power harness Mounting
Bracket for Desks at desired location.
2. Fasten the Plugmold mounting rail
(A) to the spring nuts using (3) M6
x 10mm machine screws (C).
3. Fasten the back (base) portion of the
Plugmold assembly (D) with the #8 flat
head screws provided with the assembly.
(A) 3AB504501*
(D) YRPM361/ YRPM362
Note: These Plugmolds are standard
pattern numbers, not parts.
4. To connect the building electrical system to
the pre-wired simplex outlets, first feed wires
through and attach a cable exit cover to the
end of the front cover portion of the Plugmold
assembly (D). Connect outlets, as required.
Note : Plugmold components conform
with, and should be installed and properly
grounded in compliance with requirements
of the current National Electrical Code or
codes administered by local authorities.
(B) 3AB402196 (C) 3AB4067
: All electrical products may
Note
represent a possible shock or fire hazard
if improperly installed or used.
5. To close the Plugmold assembly after wiring,
engage the lower bead of the cover in the
base. Starting at one end and progressing
along the unit, snap in the upper bead,
striking sharply with the heel of your hand.
6. Connect all Plugmold sections as required,
capping the final Plugmold section in
the run with a flat end cover included
with the Plugmold Assembly (D).