Table of Contents
Advertisement
CHAPTER
SERIAL PROGRAMMING
1 1
COMMANDS
The serial programming commands can be used in place of the programming bar
codes. Both the serial commands and the programming bar codes will program the
scanner. For complete descriptions and examples of each serial programming
command, refer to the corresponding programming bar code in this manual.
The device must be set to an RS232 interface (see
mands can be sent via a PC COM port using terminal emulation software.
Conventions
The following conventions are used for menu and query command descriptions:
parameter
[option]
{Data}
bold
Menu Command Syntax
Menu commands have the following syntax (spaces have been used for clarity
only):
Prefix [:Name:] Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] [...] Storage
Prefix
:Name:
Solaris 7980g User Guide
A label representing the actual value you should send as part of a
command.
An optional part of a command.
Alternatives in a command.
Names of menus, menu commands, buttons, dialog boxes, and win-
dows that appear on the screen.
Three ASCII characters: SYN M CR (ASCII 22,77,13).
To send information to the scanner (with the base connected to
host), use :Solaris: The default factory setting for a Solaris scanner is
Solaris scanner. This setting is changed by using the BT_NAM com-
mand, which accepts alphanumeric values. If the name is not known,
a wildcard (*) can be used :*
page
14). The following com-
183
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
