Configuring With The Wbm; Starting Wbm - Siemens SIMATIC RF185C Operating Instructions Manual

Configuring with the WBM

The communication modules are equipped with a Web server that provides Web Based
Management (WBM) to the Web client for configuring the communication modules. The
WBM can be called via the Web browser of a PC/laptop.
The WBM server provides the Web client (PC/laptop) with the parameter data of the
communication module and accepts parameter changes from the Web client. Note that
changed parameter values are not automatically transferred to the communication module.
You must always manually transfer changes to the configuration to the communication
module.
In the following, the term "WBM" is used to represent the WBM interface displayed in the
Web browser.
Figure 7-1
7.1

Starting WBM

Note
Up-to-date screenshots
Note that the following screenshots may not reflect the current firmware version.
Requirement
The communication module is connected, turned on and ready for operation ("RUN" LED is
lit or flashing green) and the relevant communication module has been assigned an IP
address.
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03
Design and function of the WBM
7
61