General Notes On Working With The Uhf App Version - Siemens SIMATIC Ident RF360M Operating Instructions Manual

Information
Reader firmware
version
MCon version
Hardware type
Hardware version
Ftim
Presence
Third-party
software
Head module
licenses
5.3

General notes on working with the UHF app version

All transponders have so-called communication protocols that control communication
between the reader and transponder. For transponders in the UHF frequency range (RF600
transponders), these communication rules are stored in EPCglobal UHF Class 1 Gen 2 and
valid for the protocols ISO 18000-62 and ISO 18000-63.
Transponder memory configuration
As a rule, each UHF transponder has 4 memory areas (memory banks) in which different,
memory area-specific information is stored.
Figure 5-12
• RESERVED
Contains Access and Kill password
This memory area is optional and is not present with all transponder types.
• EPC
Contains the EPC (electronic product code), a checksum, and protocol information
Mobile reader SIMATIC RF360M/RF660M
Operating Instructions, 08/2022, C79000-G8976-C660-02
Description
Version specification of the reader firmware of the head module
Version specification of the module controller of the head module interface.
Information on the hardware type of the head module
• A: Head module with internal antenna
• B: Head module with external antenna connector
Detailed information on the hardware version of the head module
Specification of the transponder type
Operation with presence check (fixed value)
Link to the file with copyright information on the open source software
contained in this product as well as its license conditions
Link to the file with copyright information on the open source software
contained in this head module as well as its license conditions
Memory configuration
5.3 General notes on working with the UHF app version
"SIMATIC Mobile Reader" app
51