Siemens SIMATIC RF185C Operating Instructions Manual page 18

Description
3.3 User-specific procedure
Procedure as an OPC UA user
1. Connect the hardware
You can find information on this in the section "Connection (Page 27)".
2. Assign the IP address / device name
You can find information on this in the section "Assigning the IP address / device name
with SINEC PNI (Page 50)".
3. Configure the communication module
You can find information on this in the section "Configuring with the WBM (Page 61)".
4. Program reader commands
You can find information on this in the section "Programming via OPC UA (Page 115)".
Procedure as XML user
1. Connect the hardware
You can find information on this in the section "Connection (Page 27)".
2. Assign the IP address / device name
You can find information on this in the section "Assigning the IP address / device name
with SINEC PNI (Page 50)".
3. Configure the communication module
You can find information on this in the section "Configuring with the WBM (Page 61)".
4. Program the reader commands
You can find information on this in the section "Programming via XML (Page 113)".
Procedure as Rockwell user
1. Connect the hardware
You can find information on this in the section "Connection (Page 27)".
2. Assign the IP address / device name
You can find information on this in the section Assigning the IP address / device name
with SINEC PNI (Page 50)" or "Assigning an IP address via DHCP (Page 51)".
3. Configure the communication module
You can find information on this in the section "Configuring with Studio 5000 Logix
Designer (Page 60)" and "Configuring with the WBM (Page 61)".
4. Configure / program the reader commands
You can find information on this in the section "Programming via Rockwell controller
(Page 143)".
18
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03