Block-Specific Error Messages - Siemens SIMATIC RF185C Operating Instructions Manual

A.3.5

Block-specific error messages

Table A- 5
Block
FB 45
Ident profile
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03
A.3 Operation of optical handheld readers, access control readers or serial devices
Block-specific error messages
Error ID Meaning
0x06 Negative acknowledgment or bad frame from the reader
0x05 Unknown command, incorrect command parameters or forbidden
command chaining (wrong length information)
0x0D Address error in the command (≠ "0x0000", "0x0002", "0xFFFF)
0x12 Internal communication error
0x13 New data was received before existing data was fetched.
•
With the "Write" command the oldest acknowledgments are lost
without an error message being generated.
0x18 "Init_Run" necessary
0x1F Active command was canceled by "Reset" (init_run) or bus con-
nector was unplugged
0xE2FE01 Negative acknowledgment or bad frame from the reader
0xE6FE01 Unknown command, incorrect command parameters or forbidden
command chaining (wrong length information)
0xE1FE03 Address error in the command (≠ "0x0000", "0x0002", "0xFFFF)
0xE4FE8D Internal communication error
0xE4FE04 New data was received before existing data was fetched.
•
With the "Write" command the oldest acknowledgements are lost
without an error message being generated.
0xE6FE05 "Reset_Reader" necessary
0xE5FE04 Invalid data block number (DBN) on the reader/communication
module
Scan operation: The newest data is lost.
Scan operation: The newest data is lost.
Appendix
193