The "Settings - Communication" Menu Item - Siemens SIMATIC RF185C Operating Instructions Manual

Configuring with the WBM
7.3 The menu items of the WBM
Click the button
events.
Table 7- 9
Event
Transponder
processed
Input change
Output change
Note
Reaction time of the digital outputs
Note that the reaction time of the digital outputs (and inputs) depends on the CM load and is
50 - 100 ms on average.
Note the following properties of the digital outputs:
● The outputs are only changed once when the event occurs.
The outputs remain set unchanged even when the event is no longer pending.
● Pending events have no effect on the output.
7.3.5

The "Settings - Communication" menu item

The "Settings - Communication" menu item is divided into the following tabs.
● Network interfaces
● PLC
● XML
● OPC UA
In the "Network interfaces" tab, you can enable/disable the network ports, SNMP and NTP
protocols. You can disable STEP 7 access in the "PLC" tab. In the "OPC UA" tab, you can
enable and edit the OPC UA server function of the communication module.
80
to add new events. Click the button
Description of the events
Description
If a transponder was successfully processed by the selected read point, the
output is changed to the state specified here.
If the state at the selected digital input changes, the output is set to the state
specified here.
If the state at the selected digital output changes, the output is set to the state
specified here.
to remove already specified
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03