2.11
Error messages
The following error messages are recognized by the RF200 system and entered in the
command acknowledgement in the "status" field.
Table 2- 19
Flashing of
red LED on
reader
00
02
05
06
12
13
19
20
21
24
25
28
30
--
ASCII protocol for RF200
Operating Manual, 11/2016, C79000-G8976-C329-04
Error codes of the RF200 readers
Error code
Description
0x00
no error
0x01
Presence error, possible causes:
The active command was not carried out completely
•
The transponder left the antenna field while the command was
•
being processed
Communication problem between reader and transponder
•
0x05
Parameter assignment error, possible causes:
Unknown command
•
Incorrect parameter
•
Function not allowed
•
0x06
Air interface faulty
0x0C
The transponder memory cannot be written, possible cause:
Hardware fault (memory faulty)
•
Write-protected transponder
•
0x0D
Error in the specified memory address (access attempted to non-
existent or non-accessible memory areas).
0x13
Buffer overflow: Insufficient buffer available on the reader for saving
the command
0x14
Serious system fault (hardware fault)
0x15
Parameter assignment error: bad parameter in RESET command
0x18
Only RESET command is permitted
0x19
Previous command is still active
0x1C
Communications error, possible causes:
Antenna is already turned off / Antenna is already turned on
•
The antenna is turned of, the command cannot be executed on
•
the air
external antenna has a short-circuit or is not connected
•
0x1E
Incorrect number of characters in frame
0x1F
Running command canceled by "RESET" command
Command and message frames
2.11 Error messages
21