Manitowoc Grove CD3340B Service Manual page 220

AXLES/DRIVE SHAFTS/WHEELS AND TIRES
3. If toe-in is incorrect, loosen the jam nuts (Figure 8-4)
securing the guide rods to the cylinder rod.
P0663
4. Using two wrenches on the guide rods (Figure 8-5),
screw in or out the two tie rods equally until both
dimensions are equal.
P0662
5. After the adjustment is correct, tighten the jam nuts
(Figure 8-4) against the guide rods.
8-4
Checking with Axle Removed from Machine
1.
FIGURE 8-4
2.
FIGURE 8-5
NOTE:
3.
Published 04/07/2015 Control # 569-00
Place two equal (one-meter) long linear bars on the
wheel sides of the hubs and lock them in place with two
nuts on the wheel stud bolt (Figure 8-6)
P0660
Measure the distance in millimeters between the bar
ends (both ends) with a tape line (Figure 8-7).
P0661
Record the minimum
measurement point.
Check that there is no difference in the measurements
(Figure 8-8). Both measurements must be the same.
A0722
CD3340B/YB4411
FIGURE 8-6
FIGURE 8-7
value, swinging the
FIGURE 8-8