Technical Specifications - Assa Abloy Besam SW300 Installation And Service Manual

4 Technical specifications

4 Technical specifications
Ensure that the door operator with technical specification below is suitable for the installation.
Manufacturer:
Address:
Type:
Mains power supply:
Power consumption:
Auxiliary voltage:
Mains fuse F1, F2:
Door weight/width
(kg/mm):
Door width:
Door weight:
Max. Inertia J:
Electro-mechanical locking
device:
Door opening angle:
Opening time (0° - 80°):
Closing time (90° - 10°):
HOLD open time:
Ambient temperature:
Relative humidity:
Drive unit weight:
Class of protection:
Degree of protection, con-
trol actuators:
Approvals:
10
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10, SE-261 44 Landskrona, Sweden
Besam SW300/SW150
100-240 V AC +10/-15%, 50/60 Hz, mains fuse max 10A (building
installation)
Note! The mains power supply shall be installed with protection
and an all-pole mains switch with isolating capability of Category
III, at least 3 mm between contacts, shall be installed according to
local regulations. These articles are not provided with the door.
Max. 300 W
24 V DC, max. 700 mA
2 x T 6,3 AH/250 V
Push arm system; EN 4-6, max 120/1400
Pull arm system; EN 4-5, max 100/1250
800-1600 mm
45-250 kg
For PUSH = 140 kg m 2
2
For PULL = 80 kg m
Inertia = Door weight x (Door width)
Selectable: 12V DC, max. 1200 mA or 24 V DC, max. 600 mA
80° - 110°
variable between 2,5 - 12 seconds
variable between 4 - 12 seconds
1,5 - 30 seconds
-20 °C to +45 °C
Max. 95%
7,6 kg
IP20
IP54
Third party approvals from established certification organizations
valid for safety in use, see Declaration of Conformity.
Issue 2014-10-28
2
/ 3
1007913-EI-9.0