Assa Abloy Besam SW300 User Manual
Swing door operator
Hide thumbs
Also See for Besam SW300:
- Installation and service manual (85 pages) ,
- Installation and service manual (94 pages) ,
- User manual (270 pages)
Related Manuals for Assa Abloy Besam SW300
Summary of Contents for Assa Abloy Besam SW300
- Page 1 User Manual Swing Door Operator Besam SW300/SW150 ASSA ABLOY Entrance Systems Original instructions...
-
Page 2: Table Of Contents
Other products from ASSA ABLOY Entrance Systems ............. Declaration of conformity ........................ © All rights in and to this material are the sole property of ASSA ABLOY Entrance Systems AB. Copying, scanning, alterations or modifications are expressly forbidden without the prior written consent of the applicable company within ASSA ABLOY Entrance Systems AB. - Page 3 Instructions for safe operation Failure to observe the information in this manual may result in personal injury or damage to equipment. To reduce the risk of injury to persons - use this oper- ator with single or double pedestrian swinging or folding doors only.
-
Page 4: Congratulations On Your New Automatic Door
Your local ASSA ABLOY Entrance Systems-authorized representative is familiar with these standards, as well as all applicable local codes and ASSA ABLOY Entrance Systems recommendations for power- operated pedestrian doors. Service and adjustments performed by your ASSA ABLOY Entrance Sys- tems-authorized representative, will ensure safe and proper operation of your automatic door unit. -
Page 5: Warranty
ASSA ABLOY Entrance Systems-authorized resellers shall extend this warranty to end-users only, but have no authority to extend a greater or different warranty on behalf of ASSA ABLOY Entrance Systems. A service agreement with ASSA ABLOY Entrance Systems will help secure the availability of a fully operational system and will give priority at call-out, thus minimizing the time that the equipment is unusable. -
Page 6: Intended Use
Intended use The Besam SW300/SW150 is an automatic swing door operator developed to make life easier for everyone who can benefit from automatic doors. The Besam SW300/SW150 is a low-energy as well as a full power operator using a DC motor and a gear-reduction system to drive an arm system, which opens the door. -
Page 7: How The Besam Sw300/Sw150 Works
In fully manual use (or in case of a power failure) the Besam SW300 acts as a normal door closer. The Besam SW150 has no spring and if open at power failure, door will not close. -
Page 8: Regular Safety Checks
The door must not hit you when opening nor when closing. If you are unsure of which type of sensor you have, please contact your ASSA ABLOY Entrance Systems representative. - Page 9 CLEANING The best way to remove dust and dirt from the Besam SW300/SW150 is to use water and a soft cloth or a sponge. A gentle detergent may be used. To maintain the quality of the enamel layer, the surfaces should be cleaned once/four months period.
- Page 10 Activation by disabled people: Recommended, if applicable No entry, identifying one-way traffic: Mandatory in GB and US, if applicable Automatic door Keep clear SITAC label: Mandatory in SE Contact your ASSA ABLOY Entrance Systems service representative. For contact information, see last page. Issue 2014-09-03 1008788-EI-10.0...
-
Page 11: General Accessories
Door stop (not illustrated) Safety accessories Even though the Besam SW300/SW150 is installed to comply with all applicable safety regulations, it is possible to enhance safety/comfort with the following add-ons (please contact your local ASSA ABLOY Entrance Systems company for detailed description). -
Page 12: Service/Maintenance
(PRA-0007) available. These are used together. The table below shows the recommended interval in months, when to replace parts during preventive maintenance. Talk to your ASSA ABLOY Entrance Systems representative to learn more about our service offering. Cycles/hour in operation <10... -
Page 13: Declaration Of Conformity
IEC 60335-2-103 IEC 60335-1 EC type examination or certificate issued by a notified or competent body (for full address, please contact ASSA ABLOY Entrance Systems AB) concerning the equipment: The manufacturing process ensures the compliance of the equipment with the technical file. The manufacturing process is regularly assessed by 3rd party. - Page 14 ASSA ABLOY Entrance Systems is a leading supplier of entrance automation solutions for efficient flow of goods and people. With our globally recognized product brands Besam, Crawford, Megadoor and Albany, we offer products and services dedicated to satisfying end-user needs for safe, secure, convenient and sustainable operations.ASSA ABLOY Entrance...