Function; General Description; Specifications - Assa Abloy Corbin Russwin PED5000 Series Installation Instructions Manual

PED4000/PED5000 Series Exit Devices
with optional connections
Installation Manual

Function

1
• The M92 prefix signal switch monitors the touch bar. When the rail is depressed or dogged, the switch is
de-activated.
• The M91 prefix latchbolt monitor switch provides positive indication of latchbolt extension or retraction
when the push rail is depressed, dogged or if the latch bolt itself is depressed.
• When the M97 PE series exit device is energized and the rail is depressed, it will continuously hold the push
rail down and latch in an unlocked (dogged) position. When the device is de-energized (or power is inter-
rupted), the latch will extend.
• 910/A, 930/A, 903/A, 905/A Electromechanical Trims
• M93 prefix signal switch monitors the outside lever. When the lever is rotated, the switch is deactivated.

General Description

2
This instruction manual includes wiring instructions for all Premium Exit (PE) Series Electrified Exits Options to
ElectroLynx connector system. The correct wiring configuration must be selected depending on type and function
of the product being installed. Refer to table of contents to select appropriate wiring instruction for product op-
tions being installed. Options/prefixes can be combined and wired together, as ordered.
3

Specifications

Electromechanical Exit Trim
Fail Safe Models:
910/A without cylinder
903/A with cylinder
Motor
Type: 12 or 24VDC, Intermittent or Continuous Duty
Current draw is 400mA inrush / 15mA continuous @12VDC / 24VDC
Caution: The DC voltage applied to the electromechanical exit trim must not exceed 30VDC. If the voltage
exceeds 30VDC the motor may be damaged.
M91, M93, and M92 switch contact rating: 1A max @ 30VDC
M91 prefix (latch monitor switch)
M93 prefix (exit trim lever monitor switch)
M92 prefix (push bar signal monitor switch)
M97 prefix (electric dogging) Electromagnet current: 200mA @ 24VDC
Caution: Disconnect all input power before beginning installation to prevent electrical shock and
equipment damage. All wiring must comply with applicable local electrical codes, ordinances and
regulations. Installer must be a trained, experienced service person.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Fail Secure Models:
930/A without cylinder
905/A with cylinder
3
FM575 01/23