16 Cover
16
Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made
of black painted steel sheet.
16.1
Fitting and removing the cover
The cover is slid over flanges in the back plate so that the ridges fit in the grooves. Snap on the fill
cover into the slot for output shaft. Secure cover with the screw.
When properly installed and adjusted, attach the product label, which includes the CE mark on the
right side of the lower part of the operator cover (see illustration).
Apply the Besam logotype to the cover see illustration.
Only for SE: Apply the SITAC label next to the product label - see illustration.
16.2
Cover piece kit
78
25 mm
Issue 2014-10-28
XXXXXXX
XXXXXXX
XXXX
ART. NO.
TYPE
YEAR+WEEK
XXXXXX
XXXXXXX
XXXX
XXX
XX/XX
PROJECT
VAC
A
W
Hz
SERIAL NO.
Ersätter lås med fallkolv till
1 2 3 4 5 6 7 8
XX
typgodkända
slagdörrar enl. förteckning
CLASSIFICATION DIN 18650
EN ISO 9001 Certificate No: 911828, 956538
Skydd mot olyckor vid
SITAC
rörliga anordningar
1422
xxxxxxxxx
1002
SITAC XXXX
xxxxxxxxxxxxx
xxxxxxxxxxxxx
TG XXXXXXX.
SÜD
1007913-EI-9.0