Besam Sw300 Inverse Installation With Pull Arm System - Assa Abloy Besam SW300 Installation And Service Manual

Follow step
ator is turned 180° so the "INVERSE" text on the operator is visible and do not make step
VIII
.
XII
Open the door to fully open
position. Tighten the adaptor
11.5

Besam SW300 inverse installation with PULL arm system

Remove the microswitch lever (1).
Note! Set dip switch INV to ON for Inverse operation, see 12.1.1 on page 56.
1007913-EI-9.0
I XI
to in section PUSH arm system on page 36, with the difference that the oper-
fixing screw.
Issue 2014-10-28
XIII
If necessary, adjust by moving the adaptor one step at a time.
1
11 Mechanical installation
IV
and
50 Nm
50 Nm
49