Assa Abloy Besam SW300 Installation And Service Manual page 84

20 Service/Maintenance
20 Service/Maintenance
Regular inspections shall be made according to national regulations and product documentation
by a ASSA ABLOY Entrance Systems-trained and qualified technician. The number of service occasions
should be in accordance with national requirements and product documentation. This is especially
important when the installation concerns a fire-approved door or a door with an emergency
opening function.
As with all other technical products, an automatic door needs maintenance and service. It is essential
to know the importance of maintenance to have a reliable and safe product.
Service and adjustments will ensure a safe and proper operation of an automatic door unit.
The "Service Log Book" shall be used together with the "Site Acceptance Test and Risk Assessment"
document (PRA-0007) provided. Keep both documents available for maintenance and service re-
cords.
The table below shows the recommended interval in months, when to replace parts during pre-
ventive maintenance.
PUSH Arm Service Kit
PULL/PAS arm service kit
Battery*
Transmission unit kit SW150
Transmission unit kit SW300
Transmission unit kit SW300
Transmission unit kit SW300
(not for use in DE, GB and SE)
CU-300 control unit
EXU-SI
EXU-SA
* Disconnect mains power when replacing battery.
Risk of battery explosion if wrong type of battery is used.
84
Part Part number
330000271 BK/SI
330000335 BK/SI
33738753
331009148
331007819PULL
331007819PUSH
331007819F
331008333
331003554
331003557
Issue 2014-10-28
Cycles/hour in operation
<10 <100 >100
Low Medium High
traffic traffic traffic
24 12 6
24 12 6
24 24 24
60 60 60
60 60 60
60 60 60
60 60 60
60 60 60
60 60 60
60 60 60
Abusive
Environment
6
6
24
60
60
60
60
60
60
60
1007913-EI-9.0