Technical Specifications - Assa Abloy SW200 Installation And Service Manual

4

Technical specifications

Ensure that the door operator with technical specification below is suitable for the installation.
Manufacturer:
Address:
Type:
Mains supply:
Power consumption:
Auxiliary voltage:
Mains fuse F1, F2:
Door weight/width (kg/mm):
Door width:
Max. Inertia J:
Electro-mechanical locking
device:
Door opening angle:
Opening time (0° - 80°):
Closing time (90° - 10°):
HOLD open time:
Ambient temperature:
Relative humidity:
Drive unit weight:
Class of protection:
Degree of protection, control
actuators:
Approvals:
1009728-en-9.0
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10, SE-261 44 Landskrona, Sweden
ASSA ABLOY SW200
100-240 V AC +10/-15%, 50/60 Hz, mains fuse max 10A (building installation)
Note! The mains supply shall be installed with protection and an all-pole
mains switch with isolating capability of Category III, at least 3 mm between
contacts, shall be installed according to local regulations. These articles are
not provided with the door.
Max. 300 W
24 V DC, max. 700 mA
2 x T 6,3 AH 250 V
Push arm system; EN 4-7, max. 160/1600
Pull arm system; EN 4-5, max. 100/1250
800-1600 mm
2
For PUSH = 160 kgm (80 kgm
2
For PULL = 80 kgm
Inertia = Door weight x (Door width)
Selectable: 12V DC, max. 1200 mA / 24 V DC, max. 600 mA
PUSH: 80° - 110°, with reveal 0 - 305 mm
PULL: 80° - 110°, with reveal 0 - 130 mm
PAS: only 80°-95°, with reveal 0 - 130 mm
variable between 2 - 12 seconds
variable between 4 - 12 seconds
1,5-30 seconds
-20 °C to +45 °C
Max. 95%
9 kg
IP20
IP54
Third party approvals from established certification organizations valid for
safety in use, see Declaration of Conformity.
Issue 2021-02-24
2
for 180° opening)
2
/ 3
4 Technical specifications
11