Tools Required; Installation On Double Doors - Assa Abloy Besam SW300 Installation And Service Manual

10.5

Tools required

• Metric Allen keys 1.5; 2.5; 3; 4; 5 and 6 mm
• Torque wrench
• Allen key 1.5; 2.5 and 3 mmwith spherical tip
• Torx Torx T10
• Tool for screw between cover and backplate
• Flatblade screwdriver (potentiometer and terminal size)
• Screwdriver (Philips size 2)
• Nut driver, 5 and 7 mm
• Tape rule
• Power drill and set of drill bits
• Center punch
• Wire stripper
• Silicone sealant
• Installation and Service Manual (this manual)
10.6

Installation on double doors

If the operators are to be mounted at the same height with pushing and pulling arm systems, the
height is determined by the pulling arm system, PULL. The pushing arm system PUSH must always
have a shaft extension, minimum 50 mm, maximum 70 mm to match the mounting heights visually.
Example: if PULL has a 20 mm extension, the PUSH must have a 70 mm extension. If PULL has 0 mm
extension, the PUSH must have a 50 mm extension.
For installation, follow the instructions for the applicable arm system. If using a closing coordinator,
see page 51 before starting the installation.
1007913-EI-9.0 Issue 2014-10-28
10 Pre-installation
31