Electrical Connection - Assa Abloy Besam SW300 Installation And Service Manual

12 Electrical connection

12 Electrical connection
Note! During any work with the electrical connections the mains power must be disconnected.
• Place the electric switch easily accessible from the operator.
• The operator is intended for fixed installation only with cable entry from the backplate. It is not
designed for cable entry from the side plates.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
See Auto-learn automatically sets back and latch check (recommended) on page 68.
Mains connection
a Switch off the mains power.
b Connect the plug contact to the wall socket or connect to the mains switch.
Alt. 1 (Standard)
Remove the protective lid (1) and connect the incoming mains power through the strain relief (2)
to the connection block (3).
3
54
1
Issue 2014-10-28
2
1007913-EI-9.0