Ethernet Configuration Commands; Ethernetspeed; Ipaddress; Ipdhcp - ATTO Technology FibreBridge 1190E Installation And Operation Manual

7.1.7 Ethernet configuration commands

The ethernet configuration commands configure the Ethernet and TCP/IP parameters for FibreBridge
models with Ethernet ports.
CLI commands are case insensitive (upper and
lower case allowed anywhere).

EthernetSpeed

Sets/displays the current speed of the Ethernet connection.
Limits: [ 10 | 100 | Auto ]
Actions: set EthernetSpeed xxx.xxx.xxx.xxx
SaveConfiguration

IPAddress

Sets/displays the current FibreBridge IP address.
Limits: If IPDHCP is enabled (see below), get command
reports current IP address assigned by DHCP server
Actions: set IPAddress xxx.xxx.xxx.xxx
SaveConfiguration

IPDHCP

Selecting DHCP allows the FibreBridge to request an IP address from the network.
Limits: The network must have at least one DHCP server
Actions: set IPDHCP [enabled | disabled]
SaveConfiguration

IPGateway

Sets/displays the current gateway.
Limits: If IPDHCP is enabled (see above), get command
reports current IP gateway assigned by DHCP server
Actions: set IPGateway xxx.xxx.xxx.xxx
SaveConfiguration

IPSubnetMask

Sets/displays the current subnet mask.
Limits: If IPDHCP is enabled (see above), get command
reports current subnet mask assigned by DHCP server
Actions: set IPSubnetMask xxx.xxx.xxx.xxx
SaveConfiguration
Commands generally follow a standard format:
[Get | Set] Command [Parameter 1 | Parameter 2] followed by
the return or enter key
Default: auto
Information: get EthernetSpeed
Returns: [10 | 100 | auto ( [10 | 100 | UNKNOWN ])]
If auto enabled, value in parentheses indicates current speed
Default IP Address: 010.000.000.001
Information: get IPAddress
Default: disabled
Information: get IPDHCP
Default: 000.000.000.000
Information: get IPGateway
Default: 255.255.255.000
Information: get IPSubnetMask
26