Ethernet Configuration Commands (Atto Fibre Bridge 3100R And 3200R) - ATTO Technology FibreBridge 2100R Software Manual

ATTO Technology, Inc.
DisplayEvent (Immediate)
Syntax: DisplayEvent <all>
Returns:
The DisplayEvent command results in a dump of the current contents of the event log to the
display. The log is filtered by the current switch settings as described in the DispEvent section. If
the optional all delimiter is provided, the display filtering is temporarily suspended and all logged
events are displayed regardless of the current event filter switch settings.
Ethernet Configuration Commands
The ethernet configuration commands are meant to configure the ethernet and TCP/IP parameters.
IPDHCP
Syntax: set IPDHCP [enabled | disabled]
Returns:
(terse)
(verbose)
Selecting DHCP allows the ATTO FibreBridge to request an IP address from the network. It
requires that the bridge be attached to a network with at least one DHCP server.
IPAddress
Syntax: set IPAddress xxx.xxx.xxx.xxx
Returns:
(terse)
(verbose)
Set/Display the current IP address of the ATTO FibreBridge. Note that the ATTO FibreBridge's
local hostname is the same as the FibreBridge Name specified above. If IPDHCP is enabled,
then the get command reports the current IP address assigned by the nameserver.
IPGateway
Syntax: set IPGateway xxx.xxx.xxx.xxx
Returns:
(terse)
(verbose)
Set/Display the current default gateway.
IPSubnetMask
Syntax: set IPSubnetMask xxx.xxx.xxx.xxx
Returns:
(terse)
(verbose)
The contents of the event log, as filtered by the current switch settings
manipulated via DispEvent.
get IPDHCP
[enabled | disabled]
IPDHCP = [enabled | disabled]
get IPAddress
xxx.xxx.xxx.xxx <(DHCP)>
IPAddress = xxx.xxx.xxx.xxx <(DHCP)>
get IPGateway
xxx.xxx.xxx.xxx
IPGateway = xxx.xxx.xxx.xxx
get IPSubnetMask
xxx.xxx.xxx.xxx <(DHCP)>
IPSubnetMask = xxx.xxx.xxx.xxx <(DHCP)>
ATTO Technology, Inc.
ATTO FibreBridge Software Manual
(ATTO FibreBridge 3100R and 3200R)
17
- -