Atto Ipbridge 1500D; Dimensions; Environment; Power - ATTO Technology 1500D Installation And Operation Manual

The ATTO iPBridge 1500D is a 1-Gigabit Ethernet to SCSI embeddable bridge for midrange
performance, cost effective solutions in SMB/SME environments.
The iPBridge 1500D includes a single Ethernet
port which may be used for either data transfer or
configuration, a serial management port and a

SCSI port.

Dimensions

7.5 inches wide
Width:
5.0 inches long
Depth:
1.76 inches
Height:
SCSI ID LED

Environment

Operating Temperature:
Ambient air should not exceed 40°C.
10-90% non-condensing
Humidity:
Recommended airflow:

Power

Plug in the 12 volt, 20 Watt wall mount adapter to
the back of the unit, then into an appropriate
power source (100-240 VAC input, 50/60 Hz).
The power source must be connected to a
protective earth ground and comply with local
3
ATTO Technology Inc. iPBridge Installation and Operation Manual

1.1 ATTO iPBridge 1500D

0-70° C external
11 cubic feet per minute.
electrical codes. Improper grounding may result
in an electrical shock or damage to the unit.
Input voltage: 12.0V DC +10%
SCSI port
The SCSI port on the iPBridge 1500D connects
storage devices into the Storage Area Network
(SAN). The port is an Ultra 3 LVD/SE SCSI bus
with 68-pin "P" interface: 160 MB/sec. maximum
throughput, downward compatible with all forms
of single-ended SCSI.
The iPBridge supports SCSI devices including
hard disk drives, tape drives, RAID controllers,
DVD and CD libraries.

Ethernet port

The 10/100/1000 GbE RJ45 Ethernet port uses
the Intel 8254x family gigabit Ethernet chipset to
support Telnet-based data transfer and
management through an ASCII-based command
line interface or ATTO ExpressNAV, a browser-
based interface.
GbE cables must be at least CAT-5E certified for
1000 Mb/sec. use.

LED indicators

A green LED on the top of the iPBridge
Activity:
blinks to show the unit is ready and to identify the
iPBridge when the CLI command
IdentifyBridge is enabled. It goes dark when
there is SCSI activity.
the SCSI bus has an LED which is
SCSI Activity:
lit when the iPBridge is ready and goes dark when
there is SCSI activity.

Reset switch

A manual reset switch is mounted on the back of
the iPBridge to restore factory defaults.