Monitored Data - ABB RELION 611 Series Technical Manual

Section 4
Protection functions
Table 83: PHHPTOC Non group settings (Advanced)
Parameter
Minimum operate time
Reset delay time
Measurement mode
Table 84: PHIPTOC Group settings (Basic)
Parameter
Start value
Start value Mult
Operate delay time
Table 85: PHIPTOC Non group settings (Basic)
Parameter
Operation
Num of start phases
Table 86: PHIPTOC Non group settings (Advanced)
Parameter
Reset delay time
4.1.1.10
104
Values (Range) Unit
20...60000 ms
0...60000 ms
1=RMS
2=DFT
3=Peak-to-Peak
Values (Range) Unit
1.00...40.00 xIn
0.8...10.0
20...200000 ms
Values (Range) Unit
1=on
5=off
1=1 out of 3
2=2 out of 3
3=3 out of 3
Values (Range) Unit
0...60000 ms

Monitored data

Table 87: PHLPTOC Monitored data
Name
START_DUR
PHLPTOC
Step Default
1 20
1 20
2=DFT
Step Default
0.01 1.00
0.1 1.0
10 20
Step Default
1=on
1=1 out of 3
Step Default
1 20
Type Values (Range)
FLOAT32 0.00...100.00
Enum 1=on
2=blocked
3=test
4=test/blocked
5=off
1MRS757454 D
Description
Minimum operate time for IDMT curves
Reset delay time
Selects used measurement mode
Description
Start value
Multiplier for scaling the start value
Operate delay time
Description
Operation Off / On
Number of phases required for operate
activation
Description
Reset delay time
Unit Description
% Ratio of start time /
operate time
Status
Technical Manual
611 series