Telnet Command Reference; Camera And Video Management Commands - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

Telnet Command Reference

Vaddio's Telnet command protocol allows external devices
to control the camera. Network connectivity and a Telnet
client are required; Telnet port 23 is used. Telnet sessions
require the administrator account login.
In addition to the camera control commands, Telnet session
management commands are available – help, history, and
exit.
Things to know about Telnet:
By default, Telnet access is disabled in all firmware
n
releases issued after mid-December 2019. Enable it on the Security page of the web interface.
The > character is the command prompt.
n
Using a question mark as a command parameter will bring up a list of available subcommands or
n
parameters. Example:
camera focus ?
camera focus
near Focus the camera near
far Focus the camera far
stop Stop the camera focus
mode Camera focus mode
CTRL-5 clears the current serial buffer on the device.
n
Typographical conventions used in this manual:
{ x | y | z } – Choose x, y, or z. Example: camera led { on | off | toggle }
n
<variable> – Substitute the desired value here. Example: camera ccu get <param>
n
< x - y > – Valid range of values is from x through y. Example: camera ccu set detail <0 -15>
n
[parameter] – Parameter is not required. Example: camera pan left [<speed>]
n
Note
Most of these commands are common to all Vaddio cameras. Some of the examples may not reflect the
camera you have.

Camera and Video Management Commands

The following camera and video management commands are available:
camera home
n
camera pan
n
camera tilt
n
camera zoom
n
camera ptz-position
n
camera focus
n
camera preset
n
camera chained-preset
n
camera ccu get
n
camera ccu set
n
camera led
n
camera icr
n
video mute
n
camera standby
n
48