Table of Contents
Advertisement
3 Installation
3.1 Device Installation
Ceilling or wall
Expansion bolt
Dome camera body
ST3 self-tapping screws
Dome camera enclosure
Enclosure secure screws
Step1
Use inner hexagonal wrench to loose the three inner hexagon screws in the dome cover and open the cover.
Step 2
Take the installation installation template in the accessories bag, and then paste it on the ceiling or the wall according to your
monitor area requirements. Draw and dig three plastic expansion bolts holes in the installation surface and then insert three
expansion bolts in the holes. Secure these three bolts firmly. Dig a "cable exit hole" in the surface according to the installation
position map and draw out the cable from the top of the installation surface.
Step 3
Adjust the device to the proper position and draw the cable through the cable exit, dug in the ceiling (wall). Line up the TOP
direction of the device to the installation position map and then line up the three screw holes in the device pedestal to the three
plastic expansion bolt holes in the installation position. Put the three self-tapping screws in the three plastic expansion bolts
firmly.
Step 4
Loosen the two M3 secure screws of the lens rotation structure (do not remove, loosen a little bit will be OK.). Use the inner
hexagonal wrench to insert them to the inner hexagonal holes and use the wrench to turn the lens. Adjust the lens to the proper
monitor angle and secure the screws of the lens rotation structure. The lens adjust angle ranges are: flip (0°~+75°), video pan
rotation (-15°~+15°) , video rotation angle(-15°~+15°).
Step 5
Line up the dome camera cover to the cable exits and put the cover back. Use the inner hexagonal wrench to secure the three
inner hexagonal screws firmly.
Note:
The device GND cable can effectively enhance the device reliability. The GND hole is near the cable exit of the back of the
enclosure.
11
Advertisement
Table of Contents
