Telescope End Panels For Single Sided Table - Knoll Antenna Telescope Installation Instructions And Parts Manual

Telescope End Panels for Single Sided Table

LH Back Panel, LH End Panel, RH Base
Single Sided Base Assembly with Back & End Panels,
Axonmetric View, LH Back Panel, LH End Panel, RH Base
Steps:
Notes:
These directions are to be used in
conjunction with the installation instructions
for Telescope Single Sided Table Bases with
Beam (with or without Utility Tray), Stand-Alone
Application. The instructions below only address
the modifications necessary to connect a single
sided table to an end panel application.
Before attaching an End Panel, the handed
single sided table should be fully assembled.
The crossbar adjacent to the end panel must
be a "mid-crossbar" type, with drillings on
the outer side to accept Dovetail Linking
Brackets & End Panel Connector Links.
The connector link that came with the table
too wide
base will be to properly connect
the End Panel to the base and should be
discarded for this end-panel application.
Antenna Telescope Installation Instructions
® ™
October 2018
Single Sided Base Assembly with Back & End Panels Plans View
PREPARE TABLES FOR CONNECTION:
Please refer to instructions for Telescope
Single Sided Table Bases with Beam (with or
without Utility Tray), Stand-Alone Application,
and complete the following steps to prepare
the table for connection to the End Panel.
Follow steps 1-5
to prepare legs and crossbars.
*Note variables for Step 4:
There will be different
drilling patterns on the crossbars. Single Sided
Crossbars in an "end" location will have holes
on the inner side to accept the legs at front and
beam at back (and utility trays in center, where
specified). Single Sided Crossbars at an "end
panel" location will have additional drillings on the
outer side to accept End Panel Connector Links.
Follow steps 6-8
to connect beam to crossbars.
Follow steps 9-10
to connect crossbars to legs.
Antenna
LH Back Panel, RH End Panel, RH Base
Single Sided Base Assembly with Back & End Panels,
Axonmetric View, RH Back Panel, RH End Panel, LH Base
Follow steps 11-14
*Note addition for Step 14:
x .35 bushings (M) into the side of the back
panel, and follow by inserting (3) #10-24 x
3/ zinc flat head shoulder screws (L).
8
Follow steps 19-20
trays (where applicable).
Follow steps 21-23
Follow steps 24-26
adjustment electrical components.
Follow steps 27-28
the pair of columns in each station.
Telescope
®
™
to prepare & install back panel.
Insert (3) 10-24
to install utility
to level tables.
to install the height
to perform a reset for
82