Knoll Antenna Telescope Installation Instructions And Parts Manual page 36

Telescope Dual Table Bases with Mixed or Fixed Base
Pattern Numbers Represented:
YBTFS_ _ _ _ _
Telescope Base, Fixed Height,
Telescope Base, Mixed Standard Electric
YBTFES_ _ _ _ _
and Fixed Height,
Parts List:
Right Hand Fixed Column Leg Assembly
Left Hand Fixed Column Leg Assembly
Ballast Kit
Additional Parts:
See Parts List from Telescope Dual Table Bases
with Beam (with or without Dual Utility Trays)
Tools Needed:
See Parts List from Telescope Dual Table Bases
with Beam (with or without Dual Utility Trays)
STEPS
NOTE
: The following instructions are to be used
in conjunction with the installation instructions for
Telescope Dual Table Bases with Beam (with or
without Dual Utility Trays). The instructions below
only address the slight modification required
for the preparation of the fixed leg assembly.
TO PREPARE FIXED LEGS:
1. Drop one ballast kit into both the Right Hand
and Left Hand Column Leg Assemblies. DO
NOT REMOVE THE BALLAST FROM THE BAG.
Antenna Telescope Installation Instructions
® ™
October 2018
(A) 3AF4093R*
TO CONTINUE INSTALLATION:
Please refer to instructions for Telescope Dual Table
Bases with Beam (with or without Dual Utility Trays).
Follow steps 1-5 to prepare legs & crossbars.
Follow steps 6-8 to connect beam to crossbars.
Follow steps 9-10 to connect crossbars to legs.
Follow steps 11-12 to install rails.
Antenna
(B) 3AF4094L*
Follow steps 13-14 to install utility
trays (where applicable).
Follow steps 20-22 to attach connector
links/connect tables (where applicable).
Follow steps 23-24 to level tables.
Follow steps 25-26 to install tops.
Telescope
®
™
36