Knoll Antenna Telescope Installation Instructions And Parts Manual page 85

Telescope End Panels for Single Sided Table
Left Hand Single Sided Base
CONNECT END PANEL:
7. Position the End Panel in position, located
so that the Keyhole Plates (J) are in line
with the shoulder screws (L) in the end of
the back panel, and the Dovetail Linking
Brackets (B) are in line with the End Panel
Connector Links (A). Hook the Keyhole
Plates onto the shoulder screws.
8. Position End Panel Leg Brace (D/E), just above
the corresponding End Panel Block (B) on
the End Panel with the curved (taped) surface
against the inner (toward the other column)
surface of the column. Slide the brace down
to engage the End Panel Block (B), and attach
using a ¼-20 x .5", Black Flat Head Screw (I).
Antenna Telescope Installation Instructions
® ™
October 2018
Step 7
Step 4
¼-20 x .75" Flat Head
Machine Screw (G)
Step 2 & 9
End Panel Connector Link (A)
Step 6 & 8
End Panel Leg Brace,
(Left Hand Shown) (E)
Polyurethane Grip Tape (F)
9. Raise both End Panel Connector Links (A)
off the linking brackets on the crossbar, and
reposition them as to engage both sets of
Dovetail Linking Brackets (B), i.e.: the brackets
on the crossbar and on the End Panel.
10. Extend the glides in the End Panel to level
the panel so that the End Panel Connector
Links (A) rest on the bottom flanges of both
pairs of Dovetail Linking Brackets (B).
11. Fasten the connector links (A) to the
linking brackets (B) with (1) ¼ - 20
x .75" flat head machine screw (G)
per linking bracket, from below.
Step 3
#5 x ¾ Flat Head
Wood Screw (K) Keyhole Plate (J)
Step 5
End Panel Block (C)
¼-20 x 1.25" Flat Head Machine Screw (H)
Step 8
¼-20 x .5" Black
Flat Head Screw (I)
Continue referring to the instructions
for Telescope Single Sided Table Bases
with Beam (with or without Utility Tray),
Stand-Alone Application as follows:
Follow steps 29-30
Follow step 31
ATTACH RETURNS (WHERE APPLICABLE):
See Telescope Return Base Installation Instructions.
INSTALL POWER STRIP ACCESSORY (WHERE
APPLICABLE):
See Power Strip Installation Instructions.
INSTALL CLEAT PLATE & CLEAT PLATE COVER
ACCESSORIES (WHERE APPLICABLE):
See Cleat Plate and Cleat Plate
Cover Installation Instructions.
Antenna Telescope
®
End Panel (RH shown)
Step 4
Dovetail Linking Bracket (B)
Step 11
¼-20 x .75" Flat Head
Machine Screw (G)
Step 10
End Panel Glides
to install tops.
to affix handset.
™
85