Knoll Antenna Telescope Installation Instructions And Parts Manual page 7

Telescope Dual Table Bases without Beam
and Dual Utility Trays - Standard Electric
5/16-18 x 1 1/4"
Button Head Hex
Machine Screw (L)
Step 1
Right Hand Column
Leg Assembly (A)
Exploded Table Base Without
Beam Assembly, Steps 1-3
STEPS
PREPARE LEGS & CROSSBARS:
1. Attach (2) Horizontal Rail Cradles (C) to the
upper housing boxes on the Right Hand
and Left Hand Column Leg Assemblies
(A/B), with (2) 5/16-18 x 1 1/4" button head
hex machine screws (L) per cradle.
Antenna Telescope Installation Instructions
® ™
October 2018
Horizontal Rail
Cradle (C)
Step 2
Housing
Cover (E)
1/4-20 x 5/8" Flat
Head Phillips
Machine Screw (M)
2. Attach a Housing Cover (E) to the short end
of each housing, using (2) 1/4-20 x 5/8" flat
head Phillips machine screws (M) per cover.
3. Attach a Transformer Shelf (F) to the opposite
side of each housing, using (2) 1/4-20 x 5/8" flat
head Phillips machine screws (M) per shelf.
Note: Do not attempt to rotate the outer column
tube unless the column is moving either upward
or downward. If it is necessary to orient the
welded column bracket, you must first, temporarily
connect a power supply and handset. Then plug
Antenna Telescope
®
Step 3
Transformer Shelf (F)
1/4-20 x 5/8" Flat
Head Phillips
Machine Screw (M)
Left Hand Column
Leg Assembly (B)
the power supply to building power. Depress the
Up button to run the column upward, ONLY while
the column is running, rotate the outer column tube
to orient the bracket as shown in the above image.
Lower the column and disconnect the power
supply from the building power, then from the leg.
™
7