Knoll Antenna Telescope Installation Instructions And Parts Manual page 45

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Step 11
Single Sided Back Panel
Crossbar Bracket, LH (AA)
11. Attach a Single Sided Back Panel Crossbar
Bracket, LH (AA) to the pre-drilled holes
in the left side of the back panel with (2)
/ -18 x .75" button head hex machine
5
16
screws (DD). Repeat on the right side with a
Single Sided Back Panel Crossbar Bracket,
RH (BB). Ensure that the gusset webs
are facing outward for both brackets.
Antenna Telescope Installation Instructions
® ™
October 2018
/ -18 x .75" Button Head
5
16
Hex Machine Screw (DD)
Step 12
¼-20 x ¾" Flat Head Phillips
Machine Screws (CC)
Exploded Single Sided Table Base Assembly,
Steps 11-14: Back Panel Installation, Show from Below
12. Stand the back panel up and hold it in
place. Have a second installer position
the base assembly so that the back panel
crossbar brackets (AA/BB) enter the back
of the crossbars. Ensure the bottom flange
of both brackets is BELOW the Rivnuts
inside the crossbars. Attach the brackets
to the crossbars, using (2) ¼-20 x ¾" flat
head Philips machine screws (CC) per
bracket, from below the crossbars.
Antenna
Back Panel
13. Insert (2) M6-1 spring nuts (Y) into the
underside of the beam, and attach
a Single Sided Centerbeam Bracket
(EE) to each, loosely, with a M6-10mm
button head hex machine screw (FF).
14. Align the (2) Single Sided Centerbeam Brackets
with the predrilled holes in the back panel, and
attach the brackets to the panel, with (2)
x .75" button head hex machine screws (DD)
each. Tighten the (2) M6-10mm button head hex
machine screws (FF) in underside of the beam.
Telescope
®
™
Step 13 & 14
M6-1 Spring Nut (Y)
5 / -18 x .75" Button Head
16
Hex Machine Screw (DD)
M6-10mm Button Head
Hex Machine Screw (DD)
Single Sided Centerbeam
Bracket (EE)
/ -18
5
16
45