Knoll Antenna Telescope Installation Instructions And Parts Manual page 35

Telescope Dual Table Bases with Beam (with or
without Dual Utility Trays) - Extended Electric
Worksurface Tops
Handset
Control Switch (J)
#6 x 5/8" Wood
Screws (K)
#14 x 1" Flat
Head Wood
Screws (S)
ATTACH CONNECTOR LINKS/ CONNECT
TABLES (WHERE APPLICABLE)
23. Attach (2) Dovetail Linking Brackets (BB) to
the outside of the crossbar using (2) 1/4 -20 x
3/4" flat head machine screws (CC). The base
of the "L" should be oriented downward.
24. Prepare the Connector Link (EE) for the Wire
Hanger (DD) by loosely screwing (2) 1/4-20 x
3/4" button head machine screws (V) into the
underside of the connector link. Leave a gap of
about 3/16" beneath the head of the screws.
Place the wire hanger over the heads of the
screws and slide to engage the keyhole slots.
25. To connect tables, position both table assemblies
side by side so the prepared connector links (EE)
can be slid down onto the linking brackets (BB)
previously attached to the crossbars. Fasten
the connector links to the linking brackets with
a 1/4 -20 x 3/4" flat head machine screw (CC).
Antenna Telescope Installation Instructions
® ™
October 2018
Spacer (Q)
#12 X 3/4" Flat Head
Black Wood Screw (R)
LEVEL TABLES
26. Place the tables in their final positions and level
by extending the leveling glides as needed.
27. When levelers are extended more than
1/2", install the Helical Glide Shroud. See
Helical Glide Installation Instructions.
INSTALL TOPS
28. Lay tops on base assembly. Place a Spacer (Q)
between the top of each rail and the underside
of the top, centered on the width of the top.
Spacers are attached to the top using (1) #12 X
3/4" flat head black wood screw (R) per spacer.
Note: Back to back tops are to be 6" apart.
29. Attach tops using (4) #14 x 1" flat head
wood screws (S) per cradle.
Note: Several screw hole locations are directly
above the crossbars, so it is convenient to raise
the station to make room for the power driver.
Antenna
Mid Crossbar (H)
Dovetail
Linking
Bracket
(BB)
Connector
Link (EE)
Wire Hanger
(DD)
Attaching Connector Links
Detail, Steps 23-25
Exploded Table Base with Beam
Assembly, Steps 23-30
AFFIX HANDSET
Note: If a return is to be attached, skip
this step and follow Telescope Return
Base Installation Instructions.
30. Using (2) #6 x 5/8" wood screws (K) mount the
Handset Control Switch (J) to the underside
of the worktop, at the front edge.
ATTACH RETURNS (WHERE APPLICABLE)
See Telescope Return Base Installation Instructions.
INSTALL POWER STRIP ACCESSORY
(WHERE APPLICABLE)
See Power Strip Installation Instructions.
INSTALL CLEAT PLATE & CLEAT PLATE COVER
ACCESSORIES (WHERE APPLICABLE)
See Cleat Plate and Cleat Plate Cover
Installation Instructions.
INSTALL Z-MANAGER ACCESSORY (WHERE
APPLICABLE)
See Z-Manager Installation Instructions.
Telescope
®
™
1/4 - 20 x 3/4"
Flat Head
Machine
Screws (CC)
1/4-20 x 3/4"
Button Head
Machine
Screws (V)
35