Knoll Antenna Telescope Installation Instructions And Parts Manual page 24

Telescope Dual Table Bases without Beam
and Dual Utility Trays - Extended Electric
4. Place a Pull Block (I) into each end of the (2)
Beamless Trayless Starter Crossbars (G),
and attach securely with (2) 5/16-18 x 3/4"
flat head hex machine screws (N) per pull
block in the underside of the crossbar.
Antenna Telescope Installation Instructions
® ™
October 2018
Beamless
Trayless Starter
Crossbar (G)
5/16-18 x 2"
Button Head Hex
Machine Screw (O)
Exploded Table Base Without
Beam Assembly, Steps 4-6
CONNECT CROSSBARS TO LEGS:
5. With the legs and crossbars upside down,
connect the leg assemblies to the crossbars
by sliding the ends of the crossbars onto the
welded column brackets, and joining with (2)
5/16-18 x 3/4" flat head hex machine screws
(N), loosely, into each bracket. Do not tighten
at this time. Allow the screws to seat in the
counter sinks and perform the next step.
Step 4
Pull Block (I)
5/16-18 x 3/4" Flat Head
Hex Machine Screw (N)
Steps 5 & 6
Washer (P)
Antenna Telescope
®
5/16-18 x 3/4" Flat Head
Hex Machine Screw (N)
6. Place a washer (P) on a 5/16-18 x 2" button
head hex machine screw (O) and insert it into
the bottom of the crossbar at an angle to
penetrate the pull block and thread into the
column bracket. Torque screw to 150 in. lbs. (17
Nm). Repeat for the three other crossbar ends.
Tighten the (4) pairs of flat head machine screws
previously left loose. Turn asembly right side up.
™
24