Knoll Antenna Telescope Installation Instructions And Parts Manual page 69

Telescope Return Bases
Steps 5, 8 & 9
Rall End Cap (J)
Longer Rail
(User Front)
PREPARE THE RAILS
5. Install (1) Rail End Cap (J) into the end
of each return rail using a rubber mallet.
6. In the longer of the two return rails,
install a Return Rail Hook Top Bracket
(G) in the uncapped end.
Antenna Telescope Installation Instructions
® ™
October 2018
Shorter Rail
Longer Rail ( User Front)
7. In the shorter of the two return rails, install
an End Cap with Support Tab (I).
ADD RAILS TO THE RETURN COLUMN
8. Slide (2) rails into the cradles on the return
column. Position them so that the longer
rail is forward (toward the user), and the
shorter rail is rearward on the return.
Position the rails so that the end cap
(J) sticks out past the cradle by ¼".
Antenna Telescope
®
Step 7
End Cap with
Step 6
Support Tab (I)
Return Rail Hook
Top Bracket (G)
Note
: The original Antenna install gauge is not
to be used to set Telescope rail positions.
9. Tighten the screws (N) in the
cradle clamp brackets (C).
™
69