Knoll Antenna Telescope Installation Instructions And Parts Manual page 106

Power and Cable Management
Telescope Hinged Cleat Plate Covers
for 120 Degree Application
Pattern Numbers Represented:
Hinged Cleat Plate Cover, YR1TCPC20
Parts List:
Rail Clip (A)
#6 x 5/8" Wood Screw (B)
Cleat Plate Cover
Pre-assembled Telescope Table with
Cleat Plate and Power Strip
Tools Needed:
Pry Bar
Phillips Screw Driver
STEPS
1. Determine the side-to-side location for
the hinged plate cover. The cover should
be mounted directly below the cleat
plate cable manager and power strip.
NOTE
: For a 48"W, 120 worksurface, the
transformer shelf on the outer leg assembly
must be removed for the cleat plate and cover
to be installed. The transformer may sit on the
cleat plate end flange if it is located on this
end of the station. The cleat plate cover will
fit between the outer and middle cradles.
For a 54" or 60"W 120 degree worksurface,
the transformer shelf should remain
installed, and the cleat plate cover may
be centered under the cleat plate.
Antenna Telescope Installation Instructions
® ™
October 2018
(A) 3AF4137
2. Attach two rail clips (A) to the back
desk rail, from behind the rail, one
on either side of the power strip.
NOTE
: If the worksurface has already been
attached, a pry bar may need to be used to
create a gap large enough to position the
clips between the worksurface and the rail.
3. Adjust the spacing of the rail clips
as necessary, and hang the cleat
plate cover (B) from the hooks at
the bottom of the rail clips (A).
Antenna
(B) 7528496
4. Rotate the cleat plate cover up so that
it engages with both rails. The back
edges should engage the back rail first,
followed by the front edge of the cover,
which will engage the front rail.
NOTE
: The cleat plate cover's back tabs
may need to be bent and adjusted for
proper fit and secure connection to rails.
5. Screw a #6 x 5/8" wood screw (B) into each
rail clip (A) to secure their placement.
Telescope
®
™
106