Knoll Antenna Telescope Installation Instructions And Parts Manual page 10

Telescope Dual Table Bases without Beam
and Dual Utility Trays - Standard Electric
Handset Control
Switch (J)
Steps 12, 13 & 14
PERFORM A RESET FOR THE PAIR
OF COLUMNS IN EACH STATION:
15. Plug the power supply into a temporary
power source. Ensure the green LED
on the power supply lights.
16. Apply approximately 100 lbs of weight to the
rails. Press and hold both UP and DOWN
buttons for ten seconds. After releasing the
buttons, press and hold the DOWN BUTTON
until both columns bottom out. Press the
UP button and the station will be ready to
perform normally. Remove the weight. Run
the station all the way up and down again to
ensure there are no issues with the columns.
Repeat the procedure above for the
opposite pair of columns.
Antenna Telescope Installation Instructions
® ™
October 2018
Power Supply and Power Cord
iDrive Cable
Exploded Table Base Without
Beam Assembly, Steps 7-21
LEVEL TABLES:
17. Place the tables in their final positions and level
by extending the leveling glides as needed.
18. When levelers are extended more than
1/2", install the Helical Glide Shroud. See
Helical Glide Installation Instructions.
INSTALL TOPS:
19. Lay tops on base assembly. Place a Spacer (Q)
between the top of each rail and the underside
of the top, centered on the width of the top.
Spacers are attached to the top using (1) #12 X
3/4" flat head black wood screw (R) per spacer.
Note: Back to back tops are to be 6" apart.
20. Attach tops using (4) #14 x 1" flat head
wood screws (S) per cradle.
Note: Several screw hole locations are directly
above the crossbars, so it is convenient to raise
the station to make room for the power driver.
Antenna
Transformer Shelf (F)
Step 20
#14 x 1" Flat Head
Wood Screw (S)
AFFIX HANDSET:
Note: If a return is to be attached, skip this step and
follow Telescope Return Base Installation Instructions.
21. Using (2) #6 x 5/8" wood screws (K) mount the
Handset Control Switch (J) to the underside
of the worktop, at the front edge.
ATTACH RETURNS (WHERE APPLICABLE):
See Telescope Return Base Installation Instructions.
INSTALL POWER STRIP ACCESSORY
(WHERE APPLICABLE):
See Power Strip Installation Instructions.
INSTALL CLEAT PLATE & CLEAT PLATE COVER
ACCESSORIES (WHERE APPLICABLE):
See Cleat Plate and Cleat Plate Cover
Installation Instructions.
INSTALL Z-MANAGER (WHERE APPLICABLE):
See Z-Manager Installation Instructions.
Telescope
®
™
Steps 12, 14, 16 & 21
Handset Control Switch (J)
#6 x 5/8" Wood
Screw (K)
Step 19
Spacer (Q)
#12 X 3/4" Flat Head
Black Wood Screw (R)
10