Knoll Antenna Telescope Installation Instructions And Parts Manual page 17

Telescope Dual Table Bases with Beam (with or
without Dual Utility Trays) - Standard Electric
Rail End Cap (T)
1/4-20 x 5/8"
Flat Head
Phillips Machine
Screw (M)
Cradle Clamp
Bracket (D)
Horizontal Rail
Cradle (C)
11. Install (8) Rail End Caps (T) onto the ends
of the rails using a rubber mallet.
12. Prepare the leg cradles for the rails by fastening
(2) Cradle Clamp Brackets (D) loosely to each
cradle (C) using (4) ¼-20 x 5/8" flat head
Phillips machine screws (M) per cradle.
Antenna Telescope Installation Instructions
® ™
October 2018
Rails
Note: The cradle clamp brackets (D) are
ALWAYS to be placed in the outer position
in the cradle (C), and the end is to be flush
with the face of the housing cover (E).
Antenna
Dual Table Base with Beam, Rail
Installation, Steps 11 ,12, 13, 14 & 15
Telescope
®
™
Note: Cradle
Clamp Brackets
(D) in Outer
Position
17