Telescope Fixed Center Screen, Fabric - Knoll Antenna Telescope Installation Instructions And Parts Manual

SCREENS

Telescope Fixed Center Screen, Fabric

Pattern Numbers Represented:
YPSCF_ _
Fixed Center Screen, Fabric,
Parts List:
Bayonet Mount Bracket (A)
Spring Nut (B)
M6-1 x 25mm Flat Head PHDR Machine Screw (C)
Screen
Pre-assembled Telescope Table
Tools Needed:
Phillip #3 Screwdriver
STEPS
Insert (4) spring nuts (B) into the top slot in the
1.
center beam (i.e. (2) per bayonet mount bracket).
2. Attach (2) bayonet mount brackets (A) loosely to
the spring nuts (B), using (2) M6-1 x 25mm PHDR
machine screws (C) per bracket. Do not tighten.
Antenna Telescope Installation Instructions
® ™
October 2018
(A) 3AB4082
3. Determine the desired screen position along the
width of the table, and adjust/slide the location
of the bayonet mount brackets (A) along the
center beam so they will correspond with the
openings on the underside of the screen.
Antenna
(B) 3AB4021 (C) 3AB405540
4. Tighten the screws (C) in the bayonet mount
brackets (A) to secure their locations.
Position the openings in the underside
of the screen over the bayonet mount
brackets (A) and push the screen down
until the screen is firmly seated.
Telescope
®
™
86