Knoll Antenna Telescope Installation Instructions And Parts Manual page 72

Telescope Y-Base Adjustable Height Tables
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS
9. Determine if the Handset Control will be
centered, or on the left or right side of the table.
10. Plug the handset cable into a housing outlet on the
chosen side. Connect one end of the iDrive Cable
into the second outlet on that side and the other
end into an outlet on the opposite side of the table.
11. Insert the Power Supply plug into the remaining
outlet on the non-handset side. Insert the power
cord into the power supply and position the
power supply on the nearest Transformer Shelf
(D) so that the green LED is visible from below.
INSTALL TOPS:
12. Lay tops on base assembly and attach tops
using (4) #14 x 1" flat head wood screws
(M) per Top Support Bracket (E/F).
Antenna Telescope Installation Instructions
® ™
October 2018
LEVEL TABLES:
13. Place the tables in their final positions
and level by extending the leveling
glide assemblies (A) as needed.
PERFORM A RESET FOR THE COLUMNS:
14. Plug the power supply into a power source. Ensure
the green LED on the power supply lights.
15. Apply approximately 100lbs of weight to the table.
Press and hold both UP and DOWN buttons for
ten seconds. After releasing the buttons, press
and hold the DOWN BUTTON until both columns
bottom out. Press the UP button and the table will
be ready to perform normally. Remove the weight.
Run the table all the way up and down again to
ensure there are no issues with the columns.
Y-Base Adjustable Height Table, Assembled
Antenna Telescope
®
AFFIX HANDSET MANAGE POWER CABLES
16. Using (2) #6 x / " wood screws (N) mount
5
8
the Handset Control to the underside
of the tabletop, at the front edge.
17. Use the supplied P-clamp kit (brackets
and screws) to neatly affix the iDrive/power
cables to the underside of the tabletop.
™
72