Knoll Antenna Telescope Installation Instructions And Parts Manual page 25

Telescope Dual Table Bases without Beam
and Dual Utility Trays - Extended Electric
Step 7
Rails
Rail End Cap (T)
INSTALL RAILS:
7. Install (8) Rail End Caps (T) onto the ends
of the rails using a rubber mallet.
8. Prepare the leg cradles for the rails by fastening
(2) Cradle Clamp Brackets (D) loosely to each
cradle (C) using (4) 1/4-20 x 5/8" flat head
Phillips machine screws (M) per cradle.
Note: The cradle clamp brackets (D) are
always to be placed in the outer position
in the cradle (C), and the end is to be flush
with the face of the housing cover (E).
Antenna Telescope Installation Instructions
® ™
October 2018
Steps 8 & 10
1/4-20 x 5/8" Flat Head
Phillips Machine Screw (M)
Cradle Clamp Bracket (D)
9. Slide the ends of (4) rails into the cradles on a
crossbar assembly. Position the rails so that the
end cap (T) sticks out past the cradle by ¼".
Note: The original Antenna install gauge is not
to be used to set Telescope rail positions.
10. Tighten the screws (M) in the
cradle clamp brackets (D).
11. Slide the free ends of the rails into the
opposite crossbar assembly and repeat
the above tightening procedure.
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS:
12. For each station, decide if the Handset
Control Switch (J) will be on the
left or right side of the table.
Antenna Telescope
®
Steps 12, 14, 16 & 21
Handset Control Switch (J)
#6 x 5/8" Wood Screw (K)
Transformer Shelf (F)
Note: Cradle
Clamp Brackets
(D) in Outer
Position
Exploded Table Base Without
Beam Assembly, Steps 7-21
Note: If a return assembly is to be attached
to the primary surface, the handset should
be temporarily located on the same side
as the return attachment. It will ultimately
be relocated to the return assembly.
13. Plug the handset cable into a housing outlet on
the chosen side. Connect one end of the iDrive
Cable into the second outlet on that side and the
other end into an outlet on the opposite side of
the table, (see User Manual for cable diagram).
14. Insert the Power Supply plug into the remaining
outlet on the non-handset side. Insert the power
cord into the power supply and position the
power supply on the nearest Transformer Shelf
(F) so that the green LED is visible from below.
™
25