Knoll Antenna Telescope Installation Instructions And Parts Manual page 49

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Side by Side Application
Pattern Numbers Represented:
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Left Hand,
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Right Hand,
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Left Hand,
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Right Hand,
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Left Hand,
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Right Hand,
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Left Hand,
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Right Hand,
Supplemental Parts List:
[See the installation instructions for Telescope Single Sided
Table Bases with Beam (with or without Utility Tray), Stand-
Alone Application for a complete list of additional parts.]
¼-20 x .75" Button Head Machine Screw (A)
¼-20 x ¾" Flat Head Phillips Machine Screw (B)
Dovetail Linking Brackets (C)
Wire Hanger (D)
Connector Link (E)
Tools Needed:
Power Drive
Phillips #2 and #3 Bits
/ ", 3/ ", ¼" Hex Bit Sockets
5
32 16
Ratchet Torque Wrench (150 in-lb) for 3/
4mm Allen Wrench
Level (or Laser Level)
Rubber Mallet
Steps:
NOTE:
These directions are to be used in
conjunction with the installation instructions
for Telescope Single Sided Table Bases with
Beam (with or without Utility Tray), Stand-Alone
Application. The instructions below only address
the modifications necessary to connect single
sided tables for a side by side application.
PREPARE TABLES FOR CONNECTION:
Please refer to instructions for Telescope Single
Sided Table Bases with Beam (with or without
Utility Tray), Stand-Alone Application, and complete
the following steps for each table to be connected.
Follow steps 1-5
to prepare legs and crossbars.
Antenna Telescope Installation Instructions
® ™
October 2018
(A) 7283140
YBTSSFESBNL_
YBTSSFESBNR_
YBTSSFEXBNL_
YBTSSFEXBNR_
YBTSSFESBTL_
(D) 3AF4090*
YBTSSFESBTR_
YBTSSFEXBTL_
YBTSSFEXBTR_
" Hex Bit Socket
16
*NOTE VARIABLES FOR STEP 4:
different drilling patterns on the crossbars. Single
Sided Crossbars in an "end" location will have
holes on the inner side to accept the legs at front
and beam at back (and utility trays in center,
where specified). Single Sided Crossbars in a
"connected" location will have additional drillings
on the outer side to accept Connector Links.
Follow steps 6-8
Follow steps 9-10 to connect crossbars to legs.
Follow steps 11-14
(B) 7418440
(E) 3AF4010*
There will be
to connect beam to crossbars.
to prepare & install back panel.
Antenna Telescope
®
(C) 3AF4009*
Follow steps 15-18
to install rails.
Follow steps 19-20
to install utility
trays (where applicable).
Follow steps 21-23
to level tables.
Follow steps 24-26
to install the height
adjustment electrical components.
Follow steps 27-28
to perform a reset for
the pair of columns in each station.
™
49