Telescope Dual Utility Tray Covers; Antenna Telescope - Knoll Antenna Telescope Installation Instructions And Parts Manual

Telescope Dual Utility Tray Covers

Pattern Numbers Represented:
YR1TTC_ _
Dual Utility Tray Covers,
YR1TTCA_ _
Dual Utility Tray Covers,
Parts List:
Cover Support Bracket (A)
Clamping Bracket (B)
Flip Door Stop (C)
M6-1 Spring Nut (D)
M6-1 x 14mm Flat Head Machine Screw (E)
8-32 x .625 Flat Head Machine Screw (F)
Tray Covers (Widths Vary Per Application)
Pre-assembled Telescope Table with Dual Utility Tray
Tools Needed:
Manual Ratcheting Phillips Head Screwdriver
Power Driver
Phillip #2 Bit
STEPS
Build a single cover support bracket assembly by
1.
loosely attaching a clamping bracket (B) to the
back of a cover support bracket (A) with an 8-32
x .625 flat head machine screw. Do not tighten
screw. Keep the clamping bracket (B) oriented
perpendicular to the support bracket (A).
Repeat for (3) more cover support bracket
assemblies. There will be 4 total per utility tray.
2. Insert the support bracket assemblies into the
utility tray. They should be positioned so that
they will support the tray covers, approximately 3
inches from the edges of the covers.
Antenna Telescope Installation Instructions
® ™
October 2018
(A) 3AF5035
(D) 3AB4021
NOTE
: The outside edges of the two
covers will align with the sides of the data
tray, leaving a gap between the covers
for the placement of a Z-manager. l.
3. For each assembly positioned, rotate the
clamping bracket (B) so it is vertical and
fits behind the lip of the utility tray.
4. Tighten the 8-32 x .625 flat head machine
screws (F) until the support bracket
assemblies are secure in the utility tray.
Antenna
(B) 3AF5009 (C) 3AB4058
(E) 3AB4056 (F) 4A22237
5. Opposite each support bracket assembly,
insert a M6-1 spring nut (D) into the slot
on the side of the center beam.
6. Position a flip door stop (C) in front of each
spring nut (D), fastening each with a M6 – 1
x 14mm flat head machine screw (E).
7. Position the utility tray covers on top of
the support bracket assemblies and door
stops, ensuring that the outside edges
of the two covers align with the sides of
the utility tray, leaving a gap between the
covers for the placement of a Z-manager.
Telescope
®
™
112