Knoll Antenna Telescope Installation Instructions And Parts Manual page 48

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Step 31
Handset Control Switch (I)
#6 x / " wood screws (J)
5
8
INSTALL TOPS:
29. Lay tops on base assembly. Place a Spacer (P)
between the top of each rail and the underside
of the top, centered on the width of the top.
Spacers are attached to the top using (1) #12 X
¾" flat head black wood screw (Q) per spacer.
NOTE:
Tops are predrilled so that the
front edge is 12" from the center of the
column leg, for all worksurface depths.
30. Attach tops using (4) #14 x 1" flat
head wood screws (R) per cradle.
NOTE:
Several screw hole locations are directly
above the crossbars, so it is convenient to raise
the station to make room for the power driver.
Antenna Telescope Installation Instructions
® ™
October 2018
Exploded Single Sided Table Base Assembly,
Steps 29-31: Top & Handset Installation
AFFIX HANDSET:
Note:
If a return is to be attached, skip
this step and follow Telescope Return
Base Installation Instructions.
31. Using (2) #6 x / " wood screws (J) mount
5
8
the Handset Control Switch (I) to the
underside of the worktop, at the front edge.
Antenna Telescope
®
Worksurface Top
Step 29
Spacer (P)
#12 x ¾" Flat Head Black
Wood Screw (Q)
Step 30
#14 x 1" Flat Head
Wood Screw (R)
ATTACH RETURNS (WHERE APPLICABLE):
See Telescope Return Base Installation Instructions.
INSTALL POWER STRIP ACCESSORY
(WHERE APPLICABLE):
See Power Strip Installation Instructions.
INSTALL CLEAT PLATE & CLEAT PLATE COVER
ACCESSORIES (WHERE APPLICABLE):
See Cleat Plate and Cleat Plate
Cover Installation Instructions.
™
48