Table of Contents
Advertisement
Automation
Section 2 The AutoInjector Module
Figure 2-13 Sample tube fitting with sample tubing
attached
2.2 AutoInjector Module
Operation
2.2.1 Setup
2-8
Note
The spring attached to the tubing prevents kinks from develop-
ing in the tubing.
25. Turn on the EZ Prep, or cycle power if the EZ Prep is
already turned on.
26. Go to T
| C
OOLS
ONFIG
size used on the EZ Prep. This allows the software to
ensure the loop doesn't get overfilled when separating
large samples. The software will display a warning if the
system is programmed to fill the loop to more than 50% of
total volume. This warning can be ignored at the discretion
of the user.
Before using the AutoInjector Module for the first time, the EZ
Prep should be configured for the proper injection loop volume.
1. Begin by going to T
2. Select the loop volume field as shown in Figure 2-14.
Note
The screen shot in Figure 2-14 depicts what is shown when a
Column Selector Module is installed. If the Column Selector
Module is not installed, this screen may appear differently.
| P
HPLC, and select the loop
REP
| C
| P
OOLS
ONFIG
REP
HPLC.
Advertisement
Table of Contents
