Table of Contents
Advertisement
Figure 4-15 Column Selector Module with attached
AutoInjector Module
Figure 4-16 Removing the Luer fitting from the EZ Prep
inject valve
Section 4 The Column Selector Module
2. Attach the AutoInjector Module to the top of the Column
Selector Module using the two screws supplied with the
module.
3. Remove the Luer fitting from the EZ Prep inject valve.
4. Remove the waste line from the EZ Prep inject valve.
Remove the check valve from this line and set it aside for
later use. Discard the waste line.
Automation
4-9
Advertisement
Table of Contents
