Table of Contents
Advertisement
Automation
Section 4 The Column Selector Module
Figure 4-2 Removing the bottom section housing nut
Figure 4-3 Removing the EZ Prep housing column inner
nut
4-2
2. Use a 1/4" nut driver to remove the nut from the bottom
section of the housing.
3. Use a 5/16" wrench to remove the nut located inside the EZ
Prep column housing.
4. Use a screwdriver to remove the two screws from the back
of the housing. The housing will come free from the EZ
Prep at this time with little effort.
5. Remove the mounting rail from the right side of the EZ
Prep by removing the two nuts from the mounting rail
using a 5/16" wrench.
Advertisement
Table of Contents
